Modifying Substation Properties

After the substation object is created, you are enabled to modify its properties and set up the parameters that are not defined in the creation process.

1. Click the substation object in the project pane.
2. Click the expand icon 《 to open the operation pane.
3. Click the Property tab.
4. Modify the property items of this substation, including name, substation type, construction nature, voltage, capacity, elevation, coordinate, etc.
   Note: The items displayed are relative to the substation type you selected. Click the item value to edit it. For items that cannot be edited, it will not be editable as others once clicked.
   Note: The default value for construction nature of self-built substation is New. You change it to Extension.
5. Set up vertexes of the self-built substation. Vertex setup is a definition on the shape of substation foundation, which is used in the project calculation of feasibility study report generation. If vertex values are not specified, during feasibility study report generation, the shape of this substation is automatically defined as a square with the length of 10 m and centered in its coordinate point.
   Note: Before substation design calculation, you must set up the vertexes.
   1. Define number of vertexes: Click the delete icon to delete the vertex of this line, or click the Add point button to add a vertex in the end.
   2. Input the coordinate of each vertex.
      Note: When the substation shape is square or rectangle with four vertexes, input the length and width and click the Calculate button. The coordinates of the four vertexes are calculated and displayed in the vertex table, and center of the vertexes is the substation coordinate point.
6. Click Save to save all modifications.